Puttying over the Indicator
The next thing I tackled was puttying up the indicator and the lower panel. I mixed up some Bondo Automotive filler and slopped it on there, trying to minimize the run-over.
Month: August 2005
Attaching the Indicator and Lower Panel
Next I used some 5-minute epoxy to secure the indicator piece in place. Note, that on the Rodd.com kits the indicator pieces are built to fit in one way. If you look on the underside of the piece, you will see a small arrow, as seen in the picture. This arrow should be facing toward the front of the…
Going the Stunt-Version Route
It should be noted that the Rodd.com kit includes a very good set of instructions, and if you’re building the standard version of this kit, you should use them. However, I am building what can be considered the “stunt” version of this prop. The main difference being the “hero” version this kit is designed to replicate and the stunt…
The Type II Phaser Project
The goal of this project is to construct a replica of the Type II Phaser as seen on later seasons of Star Trek: The Next Generation and early seasons of Deep Space Nine and Voyager. Feel free to click on any of the pictures for a larger (pop-up) version. Since I’m not a scratch-builder first, I’ll start off with…
Detailing the top graphic
As mentioned above, the last step is attaching the small greeblie on the top array. I gave it a quick test fit to make sure it fit over the protruding LED, and it fit fine. The only fit problem was getting the flat piece of resin to sit flush against the rounded surface of the top array. To remedy…
Final details
To detail the bottom portion of the tricorder, I first cut a template out of a manila folder. These two pieces will go on the bottom of the main body and flip out door. Once the templates were cut out and test fit on the bottom of the body, I used my hobby knife to cut them out of…
Time to button up
Now that I had the electronics and battery installed, the next step was to seal up the back panel. I had to do some slight arranging inside the main body to get the battery to fit completely inside, but it wasn’t too difficult. Following that , I just used the supplied screws to attach the door. I had to…
Lots of assembling
Next, I took the supplied nuts to secure the back access panel. I placed the nuts inside the main cavity and screwed them down using the included screws. I then carefully applied a bead of 5-minute epoxy around the base of the nuts to secure them to the tricorder body. Be very careful as not to epoxy the screws…