Next step is to drill the holes for the 4 protruding LEDs on the top of the tricorder. To accomplish this, I first checked to make sure the graphics were properly aligned with the LEDs on the circuit board. Once I did that, I used some tracing paper to create a template of the graphic decal that goes on…
With any kit, you should first read the instructions through in their entirety. This will give you an overall idea of what you have to accomplish and how each step fits in with the next. After reading through the instructions for the kit, I found that one of the final steps is adding a strip of velcro to the…
What would a tricorder be without all those blinking lights? Well, in my opinion, very boring. I was fortunate enough to obtain these electronic boards from the same gentleman who made the electronics for the actual Trek series props! He even used the same parts to construct these boards as were used on the the Mark VI tricorders way…